Usage Instructions

Directions for use of Price-Driscoll Liquid Mold Release Product

Use Safety Glasses for eye protection.

Start with a clean mold.

Apply with a sprayer, air brush sprayer, (i.e. Grainger or McMaster-Carr)

Hold sprayer about 12 to 15 inches away from the mold surface and spray a light mist onto the surface. Two light coats are better than one thick coat.  A little goes a long way; a lot does no better.

Over spraying may cause a build-up of mold release over a period of time and my cause piece marking.

(Following the above directions will yield more releases per application shorter cycle times, higher productivity and will increase the life of your molds.)

Suggested sprayer or spray system should be stainless steel, do not use aluminum sprayers, especially with Solvent B (n-propyl bromide).

Keep water out and away from the container that contains the mold release.  When using air compressors, use a dryer so that condensation does not occur inside the container.

Recommendations for the personal protection and safety-in-use:

Eye Protection:  Chemical googles, safety glasses with side shields.

Clothing: Wear long sleeves, chemical resistant gloves, butyl rubber or FEP Teflon gloves, coveralls, apron and boots are to prevent skin contact.

Respiration: Wear a NIOSH/MSH approved organic vapor / mist respirator or an air supplied respirator as appropriate to prevent overexposure by inhalation.

Ventilation: Use local exhaust, mechanical ventilation of confined spaces.

Select the fields to be shown. Others will be hidden. Drag and drop to rearrange the order.
  • Image
  • SKU
  • Rating
  • Price
  • Stock
  • Availability
  • Add to cart
  • Description
  • Content
  • Weight
  • Dimensions
  • Additional information
  • Attributes
  • Custom attributes
  • Custom fields
Wishlist 0
Open wishlist page Continue shopping